It can take a while and any issues are reported in RAIDar. The ReadyNAS includes a built-in Disk Test function to check all inserted disks inside the ReadyNAS. If your new ReadyNAS OS 6 failing to boot, failed disk can be a culprit. Possibilities are that these disks have been used elsewhere in a computer or even another NAS and the ReadyNAS is taking a preventive step in not wiping off the data on these disks. In case you see ERR Used Disks error message, it shows that the ReadyNAS detects existing partitions on these disks and will not employ these disks. Once done with the reset, you now need to use the Netgear ReadyNAS default password. In the event that you are not concerned with partitions or data on these disks and want to continue to wipe the disks, then perform a factory default from the Boot Menu. Alternatively, chances are that you might have inserted disks into your ReadyNAS from a different ReadyNAS model. On the off chance if you see either of these error messages, it can be because of a corrupt OS installation on the root partition. These errors can also be seen on the LCD panel if your ReadyNAS model have one. You may see error messages such as Corrupt Root, Could Not Mount Root RAID and ERR Used Disks. In case you have bought a new ReadyNAS and it doesn’t boot up, then you need to check the status of the ReadyNAS using RAIDar.
Note: All our troubleshooting steps are dependent on if you are using a new ReadyNAS or whether the disks inside the ReadyNAS have been used in the past or not. Here, you will learn various tactics to get rid of the ReadyNAS OS 6 boot failure issues. Is your Netgear ReadyNAS OS 6 failing to boot? If you nod in yes, you have landed on the right post.